Jaguar:50/60hz Switch: Revision history

Jump to navigation Jump to search

Diff selection: Mark the radio buttons of the revisions to compare and hit enter or the button at the bottom.
Legend: (cur) = difference with latest revision, (prev) = difference with preceding revision, m = minor edit.

17 February 2024

14 February 2024

  • curprev 22:2922:29, 14 February 2024‎ DanielBlack88 talk contribs‎ 1,604 bytes +68‎ Added photo to show where to install the jumper on R19 for NTSC color output.
  • curprev 21:5921:59, 14 February 2024‎ DanielBlack88 talk contribs‎ 1,536 bytes +866‎ Edited the introduction to mention the jumper for the video encoder and the clock crystal being different between PAL and NTSC motherboards, added info about changing the video encoder color ouput to NTSC(443)a nd made a templete for replacing clock cryst
  • curprev 20:5820:58, 14 February 2024‎ Derf talk contribs‎ m 670 bytes +6‎ No edit summary
  • curprev 03:3603:36, 14 February 2024‎ Derf talk contribs‎ 664 bytes +664‎ Created page with "The NTSC and PAL motherboards for Atari Jaguars are nearly identical, except for a jumper that is closed on PAL motherboards. When this 0 ohm resistor is in place, the system to run at 50Hz instead of 60Hz. == Removing the Jumper == File:Jaguar5060hz-jumper.png On the bottom side of the motherboard near controller port 2, locate the resistor. It may be marked as "R148". Heat each side and add fresh solder and remove the resistor. You may want to keep the resistor at..."
Retrieved from "https://consolemods.org/wiki/Jaguar:50/60hz_Switch"