SNES:Video Cables

Never use use an NTSC cable in a PAL system!

SNES / SFC

All original (large) versions of the Super Nintendo and Super Famicom (NTSC & PAL) can output RGB without a modification, however each region requires a different cable. The SNES Mini / Famicom Jr. require a modification before an RGB/YPbPr/HDMI cable can be used (see the SNES Jr page for more info).

RGB

• Universal RGB SCART Cable for both PAL and NTSC SNES (UK Seller)

Component YPbPr

• HD Retrovision SNES Component Video Cable
• RetroTINK Component Video Cable

HDMI

While the SNES does not output HDMI natively, you can use a cable that converts the RGB output to HDMI.

• RAD2x HDMI Cable (upscales to 480p)

SCART (RGB)

All systems (large, original version) can all output CSYNC without a modification, except the very rare 1CHIP-03. If you have a 1CHIP-03, either use luma as sync, or see the instructions below to connect CSYNC:

• Super Nintendo SNES RGB SCART cable (NTSC) (UK Seller)
• Super Nintendo SNES RGB SCART cable (NTSC)  (US Seller #1)
• Super Nintendo SNES RGB SCART cable (NTSC)  (US Seller #2)

PAL Super Nintendo

These systems output 12v on the csync pin and if you tried to use an NTSC / csync cable on a PAL system, you could damage your equipment! Also, PAL cables require different components to send the proper signals to PAL displays, so you should never use an NTSC cable on a PAL system (or vice versa).

In most scenarios, the best RGB cables to use with PAL SNES systems are either the basic-shielded cables that get sync from the luma pin, or fully shielded that get sync from cvbs (composite video).

An easier choice is the universal cable linked above:

• Super Nintendo SNES RGB SCART cable (PAL)  (UK Seller)
• Super Nintendo SNES RGB SCART cable (PAL)  (US Seller)

If your display, processor or switch requires [sync.html csync], you'll either need to use the universal cable, or make sure a sync stripper is in your setup chain. Once again, please make sure to never use use an NTSC cable in a PAL system!