Xbox 360:RGH/RGH3

From ConsoleMods Wiki
Revision as of 02:43, 3 July 2024 by Nadaman (talk | contribs) (Replaced content with "==Equipment Needed== *A soldering iron, solder, flux, and Isopropyl alcohol with cotton swabs **Specific recommendatons can be found on this page *28-30AWG Wire (Solid core recommended) *An SMD or through hole resistor, SMD preferred. ('''Required on Phat''', optional on Corona. Optional but highly recommended on Trinity.) **Falcon/Jasper/Tonasket: 22K Ohm (Red, Red, Orange, Yellow) **Trinity: 3K Ohm (Orange, Black, Red, Golden) *...")
Jump to navigation Jump to search

Equipment Needed

  • A soldering iron, solder, flux, and Isopropyl alcohol with cotton swabs
  • 28-30AWG Wire (Solid core recommended)
  • An SMD or through hole resistor, SMD preferred. (Required on Phat, optional on Corona. Optional but highly recommended on Trinity.)
    • Falcon/Jasper/Tonasket: 22K Ohm (Red, Red, Orange, Yellow)
    • Trinity: 3K Ohm (Orange, Black, Red, Golden)
      • Up to 10K Ohm can work, but Trinity consoles can occassionally have issues with RGH3 when using a high Ohm resistors like these, so it's best to use 3K when available.
    • Corona: 1K Ohm (Brown, Black, Red, Gold)
  • On Falcon/Jasper/Tonasket, an optional through hole or SMD diode of your choice, SMD preferred.
    • If you are not sure what to use, 1N4148 diodes are a decent option.
    • Highly recommended for stubborn consoles.
  • Wire Insulation (kapton tape, electrical tape, heatshrink, etc.) if using a through hole resistor/diode
  • A PC running Windows Vista or later
  • J-Runner with Extras
  • Any compatible NAND Programmer
Retrieved from "https://consolemods.org/wiki/index.php?title=Xbox_360:RGH/RGH3&oldid=44825"