AV:RetroTINK-4K

RetroTINK-4K GUI Map

Basic Setup

Input Selection

Front
Composite	information
S-Video	information

RCA
YPbPr	information
RGsB	information
CVBS on Green	information

SCART
RGBS (75 ohm)	information
RGsB	information
YPbPr	information
CVBS on Pin 20	information
CBVS on Green	information
Y/C on Pin 20/Red	information

HD-15
RGBHV	information
RGBS	information
RGsB	information
YPbPr	information
CBVS on Hsync	information
CBVS on Green	information
Y/C on Green/Red	information

HDMI
thing a	information
thing b	information

Scaling/Cropping

Input Crop
Left Trim	information
Right Trim	information
Top Trim	information
Bottom Trim	information
Vert. Pre-Scale	information

Scaler
Aspect Correction	information
Scaling Mode	information
Vert. Factor	information
Hori. Factor	information

Interpolation
Vert. Kernel	information
Hori. Kernel	information

Buffer
Length	information

Image Processing

Scanline
Function	information
Strength	information
Modulation	information
Red Bleed	information
Red Convergence	information
Blue Convergence	information

Mask
Enable	information
Strength	information
Load from File	Select a Mask File, RGB Masks:, Mono Masks:

Horizontal Blur
Function	information
Boost	information

Gamma/Linear Light/HDR
Input Factor	information
Output Factor	information
SMPTE 2048 PQ	information

Deinterlacer

Mode
Algorithm:	information
Field Inversion:	information

Motion Adaptive Settings
Sensitivity	information
Interpolator	information
Detector	information

Bob Settings
Offset	information

System

On Screen Display
Position	information
Auto-Off	information
Load Banner	information
Enable Debug OSD	information

Blanking Color:
Red	information
Green	information
Blue	information

Firmware Update
Check SD Card	information

Advanced Setup:

RGB/Component ADC

Sampling
Sampling Rate	information
Decimation Factor	information
Decimation Phase	information
Sub-Phase	information
Anti-Alias	information

Sync
SoG Threshold	information
Pre-coast	information
Post-coast	information

Gain
Pre-ADC	information
Red	information
Green	information
Blue	information

Auto Calibrate
Phase	information
Gain	information

HDMI Receiver

Receiver
Decimation Factor	information
Decimation Phase	information

Color Space
4:2:2 Upsampler	information
CSC Mode:	information
Input RGB Range	information

SDP Decoder

Gain/Balance
Brightness	information
Contrast	information
Chroma	information
Phase	information
Blue Only	information
Setup	information

Processing
Y/C Filter	information
Comb Bandwidth	information
Chroma Bandwidth	information
Sharpness	information
CTIE	information

Sync
H-Lock Speed	information
Standard	information

Audio Input

Sampling
Sampling Rate	information
Pre-amp Gain	information

Source
Input Override	information
Input Swap	information

Profiles

Load Profile
Load Default	information
Load From File	(opens file selector window titled "Select Profile")

Save Profile
Save Current	information
Save As New	information

Assign Profile
Button 1	information
Button 2	information
Button 3	information
Button 4	information
Button 5	information
Button 6	information
Button 7	information
Button 8	information
Button 9	information
Button 10	information
Button 11	information
Button 12	information
Power Up	information

Device

Status

System Status Page 1:

Video Source	CP Proc. (I assume CP Proc will change based on selection)
Input Timing	information
Pixel Clock	information

Video Source: CP Proc. (I assume CP Proc will change based on selection) Input Timing: Pixel Clock: Freq: Detected Mode: Audio Input: I2S (I assume will change based on audio input) Measured Freq: HDMI SR: HDMI N / CTS: FPGA Core Scaler Clock: PLL VCO: Pipeline: SDRAM Clock: SDRAM Load: HDMI Transmitter Output Timing: Active Size: Pixel Clock: HDMI Standard: PIC32MX MCU System Clock: Uptime: Loop Time: Last IR Code: SD Card Free:

System Status Page 2: System Status Page 3:

About

Device: FW Version Device ID: