Xbox 360:RGH/RGH1.2: Difference between revisions
Jump to navigation
Jump to search
Line 32: | Line 32: | ||
===Trinity / Corona=== | ===Trinity / Corona=== | ||
====Matrix Glitcher==== | ====[[:File:RGH1.2_Corona_Diagram.jpg|Matrix Glitcher (Corona)]]==== | ||
====[[:File:RGH1.2_Trinity_Diagram.jpg|Matrix Glitcher (Trinity)]]==== | |||
====[[:File:RGH1.2_Slim_PLL.jpg|Close-up of PLL]]==== | |||
==Programming the Glitch Chip== | ==Programming the Glitch Chip== |
Revision as of 22:08, 5 December 2021
RGH1.2 combines RGH1-like PLL slowdown with RGH2 software to allow reliable glitching of Phat consoles after 14699 dashboard.
Equipment Needed
- A glitch chip:
- Coolrunner Rev A/B/C/D or CR3 Lite
- Matrix Glitcher
- Squirt 360
- X360 ACE
- A PC running Windows Vista or later
- A soldering iron, solder, and flux (MG 835 recommended)
- Isopropyl alcohol (91% or higher recommended) and cotton swabs
- xFlasher 360, NAND-X, JR-Programmer, or Matrix Flasher
- J-Runner with Extras
Glitch Chip Installation
Falcon / Jasper
CoolRunner rev C/D
CoolRunner 3 Lite
Matrix Glitcher
Squirt 360
X360 ACE
- Note that the X360 ACE v3 needs a 22K resistor soldered on the PLL line. It needs removal of a diode on the chip itself.
Trinity / Corona
Matrix Glitcher (Corona)
Matrix Glitcher (Trinity)
Close-up of PLL
Programming the Glitch Chip
- Plug the cable from your programmer into the chip programmer.
- If you are using an xFlasher, ensure the switch is set to
SPI
. - CoolRunner: Slide switch to "PRG".
- If you are using an xFlasher, ensure the switch is set to
- Open J-Runner with Extras. Click "Program Timing File" in the upper left and select your console’s tab and the relevant radio button for RGH 1.2.
- Click "Program". When complete, unplug the cable from the glitch chip.
- Coolrunner: Set the switch back to "NOR".
Decrypting the NAND
- Connect Ethernet and power on the console. The Coolrunner should blink once or more times, and then the console should start into XeLL RELOADED.
- Once XeLL finishes, it will display your CPU key and some other info. There is also an IP address.
- Enter the IP address into the box on the lower right of J-Runner and click "Get CPU Key". J-Runner will pull the info from the box, and decrypt the NANDs automatically.
Writing New NAND Image
- Power down the console, and connect your programmer to the motherboard.
- If you are using an xFlasher, ensure the switch is set to
SPI
.
- If you are using an xFlasher, ensure the switch is set to
- In the upper right of J-Runner, ensure the
Glitch2
radio button is selected. - Click "Create XeBuild Image". This will take a few moments.
- Click "Write NAND".
- Disconnect your programmer when the process completes.
- Boot the console several times and ensure it boots consistently. If not, make sure your wiring is clean and neat and avoids noisy area. Run the wires near the X-Clamps for best results.
- Return to the RGH main page and continue in the Cleaning Up section.