Dreamcast:Digital Audio (SPDIF) Mod: Difference between revisions

From ConsoleMods Wiki
Jump to navigation Jump to search
mNo edit summary
mNo edit summary
Line 17: Line 17:
## `GND` on motherboard to `GND` on Pep Audio PCB.
## `GND` on motherboard to `GND` on Pep Audio PCB.
#: [[File:Dreamcast_SPDIF_Mod_1.jpg|400px]]
#: [[File:Dreamcast_SPDIF_Mod_1.jpg|400px]]
# Connect the output jack:
#* If using a TOSLINK port, connect +5V and GND to it. Also connect `DATA` ('''not''' `DAT`!) on the Pep Audio PCB to the `In` on the TOSLINK port.
#* If using a SPDIF port, connect `DATA` on the Pep Audio PCB to the data pin and GND to GND.
# Partially reassemble, snaking the board past the metal shield as shown below:  
# Partially reassemble, snaking the board past the metal shield as shown below:  
#: [[File:Dreamcast_SPDIF_Mod_2.jpg|400px]]
#: [[File:Dreamcast_SPDIF_Mod_2.jpg|400px]]
# Connect and mount the output jack:
# Mount the output jack on the case. Example completed install:
#* If using a TOSLINK port, connect +5V and GND to it. Also connect `DATA` ('''not''' `DAT`!) on the Pep Audio PCB to the `In` on the TOSLINK port.
#: [[File:Dreamcast_SPDIF_Mod_3.jpg|400px]]
#* If using a SPDIF port, connect `DATA` on the Pep Audio PCB to the data pin and GND to GND.
* Example completed install:
*: [[File:Dreamcast_SPDIF_Mod_3.jpg|400px]]

Revision as of 15:28, 15 July 2023

Original guide adapted from a post by citrus3000psi.

This guide assumes the DAC in your Dreamcast is a PCM1725.

Required Materials

Installation

  1. On the top of the motherboard, solder wires from these four legs on the DAC to the matching pads on the Pep Audio board.
    1. DATA on motherboard to DAT on Pep Audio PCB (not DATA!).
    2. BCK on motherboard to BC on Pep Audio PCB.
    3. LRCK on motherboard to LRC on Pep Audio PCB.
    4. MCLK on motherboard to MC on Pep Audio PCB.
    5. +5 on motherboard to 5V on Pep Audio PCB.
    6. GND on motherboard to GND on Pep Audio PCB.
    Dreamcast SPDIF Mod 1.jpg
  2. Connect the output jack:
    • If using a TOSLINK port, connect +5V and GND to it. Also connect DATA (not DAT!) on the Pep Audio PCB to the In on the TOSLINK port.
    • If using a SPDIF port, connect DATA on the Pep Audio PCB to the data pin and GND to GND.
  3. Partially reassemble, snaking the board past the metal shield as shown below:
    Dreamcast SPDIF Mod 2.jpg
  4. Mount the output jack on the case. Example completed install:
    Dreamcast SPDIF Mod 3.jpg
Retrieved from "https://consolemods.org/wiki/index.php?title=Dreamcast:Digital_Audio_(SPDIF)_Mod&oldid=24837"