CRT:Diamondtron SB VSync & HSync Unlocking Guide: Difference between revisions
Jump to navigation
Jump to search
Slim Dread (talk | contribs) (added tutorial) |
Slim Dread (talk | contribs) m (minor edit) |
||
| Line 12: | Line 12: | ||
* Change DATA Decimal in ADDR 006 to adjust the Vsync Minimum +1 (49 is 48Hz) | * Change DATA Decimal in ADDR 006 to adjust the Vsync Minimum +1 (49 is 48Hz) | ||
* Change DATA Decimal in ADDR 007 to adjust the Vsync Maximum +1 (161 is 160Hz) | * Change DATA Decimal in ADDR 007 to adjust the Vsync Maximum +1 (161 is 160Hz) | ||
* Press the EXIT button after each ADDR modification to save each address value then enter the FACT DATA-E2P menu again to change other ADDR values. | * Press the EXIT button after each ADDR modification to save each address value then enter the FACT DATA-E2P menu again to change other ADDR values. | ||
Exit the OSD. | Exit the OSD. | ||
== Notes == | == Notes == | ||
This tutorial only applies for Diamondtron SB monitors (and their rebadges) such as the 930SB, 230SB and 2070SB | This tutorial only applies for Diamondtron SB monitors (and their rebadges) such as the 930SB, 230SB and 2070SB | ||
Revision as of 22:25, 16 August 2024
Overclocking Tutorial
Diamondtron HSync & Vsync Unlocking Tutorial (NOTE: Only works on EEPROM edit mode capable monitors):
- Turn off the monitor.
- Turn on the monitor while holding the EXIT button until you see a raster image then release and press EXIT again and you will see the FACT DATA menu.
- Press the (-) button once to set the data value to 255 then press the (+) button to set the data value to 5 then press the SELECT button.
- Navigate to the right in the OSD menu until you find the FACT DATA menu again.
- Press the (+) button until the DATA value is set to 99 then press the SELECT button.
- Press either the (◀) or (▶) buttons and you will be introduced to the FACT DATA-E2P menu.
- Cycle through ADDR to change DATA values:
- Change DATA Decimal in ADDR 004 to adjust the Hsync Minimum +1 (31 is 30KHz)
- Change DATA Decimal in ADDR 005 to adjust the Hsync Maximum +1 (141 is 140KHz)
- Change DATA Decimal in ADDR 006 to adjust the Vsync Minimum +1 (49 is 48Hz)
- Change DATA Decimal in ADDR 007 to adjust the Vsync Maximum +1 (161 is 160Hz)
- Press the EXIT button after each ADDR modification to save each address value then enter the FACT DATA-E2P menu again to change other ADDR values.
Exit the OSD.
Notes
This tutorial only applies for Diamondtron SB monitors (and their rebadges) such as the 930SB, 230SB and 2070SB