Genesis:Triple Bypass Mod Model 3 VA1

From ConsoleMods Wiki
Revision as of 20:17, 20 September 2022 by MisplacedMelodies (talk | contribs) (Changed structure to match the VA2 page. Added text for Warnings and Tools Required sections.)
Jump to navigation Jump to search

This document will serve as clear and step-by-step instructions on installing the 3BP on the Genesis Model 3, revision VA1.

Warnings

Please read the below warnings before proceeding!

  • This guide expects you to have a basic understanding of how to open up your Genesis Model 3 and to have basic soldering skills.
  • This mod permanently alters your device.
  • This mod should not be done by a beginner and is considered intermediate/advanced.
  • Make sure power is disconnected before proceeding.
  • After performing this mod you will no longer be able to use composite. You’ll be required to use RGB (or HD Retrovision) cables from this point forward.
  • Proceed at your own risk!

Tools required:

  • Flush cutters
  • Snips
  • Soldering iron
  • Solder
  • Flux
  • Solder wick
  • 28 or 30 AWG wire

Installation

In the near future, full step-by-step instruction will be provided. Until then presented here are three pictures of the recommended installation method to aid in the process.

The bottom of the motherboard pre-modification.

File:Genesis 3 VA1 3BP Bottom Pre-Mod.jpg

The bottom of the motherboard post-modification.

Genesis 3 VA1 3BP Bottom Modded.jpg

The top of the motherboard post-modification.

Genesis 3 VA1 3BP Top Modded.jpg

Retrieved from "https://consolemods.org/wiki/index.php?title=Genesis:Triple_Bypass_Mod_Model_3_VA1&oldid=17176"