Dreamcast:Digital Audio (SPDIF) Mod

Original guide adapted from a post by citrus3000psi.

This guide assumes the DAC in your Dreamcast is a PCM1725.

Required Materials

• Pep Audio 1.2 PCB

Installation

1. On the top of the motherboard, solder wires from these four legs on the DAC to the matching pads on the Pep Audio board.
   1. DATA on motherboard to DAT on Pep Audio PCB (not DATA!).
   2. BCK on motherboard to BC on Pep Audio PCB.
   3. LRCK on motherboard to LRC on Pep Audio PCB.
   4. MCLK on motherboard to MC on Pep Audio PCB.
   5. +5 on motherboard to 5V on Pep Audio PCB.
   6. GND on motherboard to GND on Pep Audio PCB.

   

2. Partially reassemble, snaking the board past the metal shield as shown below:

   

3. Connect and mount the output jack:
   • If using a TOSLINK port, connect +5V and GND to it. Also connect DATA (not DAT!) on the Pep Audio PCB to the In on the TOSLINK port.
   • If using a SPDIF port, connect DATA on the Pep Audio PCB to the data pin and GND to GND.

• Example completed install: