Phat
3.3v, 5v, GND, and RGH 2 i2C
1.8V (Only if using an X360 ACE V1/V2/V3)
PLL Repair on a Phat motherboard (required if bottom pad is damaged). Image credit to TheLazyITGuy.
CPU_RST
- J8C1
- Will not work with EXT_CLK.
EXT_CLK
FT6U1 POST (RGH 1.2 or EXT_CLK)
- Bottom
- Top (requires scraping)
FT6U7 POST (RGH 1, 2, or 3)
- Bottom
- Top (requires scraping)
GND
PLL
- Bottom
- Top (under CPU heatsink; requires scraping)
STBY_CLK
- Top (Xenon)
- Top (Non-Xenon)
- There are 2 points boxed; either can be used.
SMC
- POST and PLL (Bottom)
- Alternative SMC_PLL (Top)
Trinity
3.3v, 5v, GND, and RGH 2 i2C
CPU_CLK (Only if using an X360 ACE V4/V5)
- Top (HANA)
- There are two points circled for C1 and C2 respectively; either can be used or bridged.
PLL
- Bottom
- No alternative point!
POST & RST
- Bottom
- There are two RST points, either can be used.
- Top (without postfix adapter)
- Top (with postfix Adapter)
- A Postfix adapter can be used on Trinity in case the POST point is damaged.
STBY_CLK
SMC
- SMC_PLL is also used for Muffin/Mufas
- SMC_PLL
- SMC_POST
Corona/Waitsburg/Stingray
3.3v, 5v, GND, and RGH 2 i2C
CPU_CLK (Only if using an X360 ACE V4/V5)
- Top
- There are two points circled for C1 and C2 respectively, either can be used or bridged.
PLL
- Bottom
- No alternative point!
POST & RST
- Bottom
- There are two RST points; either can be used.
- Top (without postfix adapter)
- Top (Postfix Adapter)
- If POST on the bottom is disabled (like in Waitsburg & Stingray boards) or damaged, a postfix adapter is required.
SMC
- The GPIO used for SMC_PLL is also used for Muffin/Mufas
- POST and PLL (Bottom)
- Alternate SMC_PLL (Top, Southbridge)
- Alternate SMC_PLL (Top, DB2G3)
Postfix Adapter Installation & Identification Guide