Genesis:Genesis 3 Compatibility Restore

Model 3 Genesis units can have much of the functionality of an original Genesis restored by connecting some pins on the GOAC that are missing connections to the cartridge port (see diagram below). Neither can connect to a Sega CD, but if you’re using a Mega SD or Mega EverDrive PRO, you can restore Sega CD audio by connecting B1 and B3 to a Mega Amp, Triple Bypass or the original audio circuit using 75 ohm pull-down resistors.

Genesis 3 VA1

The VA1 can have 32X, Virtua Racing, Game Genie, and Sega Master System (without FM audio) support restored by connecting wires from the following pins on the cartridge port to the Sega 315-5960 GOAC.

Completed Sega CD audio fix (green wires are the full restored function).

Cart Port Pin	315-5960 GOAC Pin
B1	Left Audio (XL)*
B3	Right Audio (XR)*
B12	Pin 24
B13	Pin 25
B14	Pin 26
B15	Pin 152
B19	Pin 151
B21	Pin 158
B30	Pin 43
B32	Pin 42

*Pin on Mega Amp or Triple Bypass board

Genesis 3 VA2

Completed compatibility fixes on a VA2 Genesis 3.

Unfortunately, the VA2 can only have Virtua Racing and Game Genie functionality restored, resulting in no expanded functionality past the Genesis library. However, you can still restore Sega CD audio.

• Connect B1 (Audio Left; XL) and B3 (Audio Right; XR) to a Mega Amp or Triple Bypass board.
• Add a short jumper wire between cartridge pins B26 and B11 as shown below.
• Run wires from the following pin B19 on the cartridge port to pin 154 on the Sega 315-6123 GOAC chip.

In addition, the VA2 has a set of jumpers which can either enable or disable the TMSS (TradeMark Security System) screen which is shown at boot. TMSS is enabled by shorting R30 (default) or disabled by shorting R27. Note that game compatibility may vary and Sega CD games cannot be loaded from the Mega EverDrive Pro or Mega SD if TMSS is disabled.