Example Page/pt

Este é um teste

v2

v3

v4

Required Materials

• Tools (T1 screwdriver, Philips screwdriver, soldering iron, etc)
• Modding products (RGB board, cable adapters, etc)
• Components (resistors, capacitors, etc)
• (Optional) Extra things that may make the mod easier or additional pieces you can add onto the mod.

Installation

Motherboard Preparation

1. Disassemble the unit.
2. Remove things from the motherboard.
3. Add things to the motherboard.
4. Bridge these pins.

Mod Installation

Choose an installation method below.

(Option 1) Preserving RF Output

This method is more difficult but preserves RF output.

1. Mount mod board at this location (picture).
2. Connect wires from here to here.
3. Set these jumpers.

(Option 2) Sacrificing RF Output

This method is much easier but removes RF output.

1. Mount mod board at this location (picture).
2. Connect wires from here to here.
3. Set these other jumpers.
4. Test the solution by checking XYZ.

Finishing Up

1. Clean up with isopropyl alcohol and test it.
2. If testing fails then check X, Y, and Z.
3. Reassemble the unit.

Usage

• Give usage instructions if necessary.
• Cover any additional options post-install, such as configuration jumpers or software settings.

Troubleshooting and Tips

• List specific tips here or common issues people run into.