Example Page/pt: Difference between revisions

From ConsoleMods Wiki
Jump to navigation Jump to search
(Created page with "v3")
(Created page with "v14")
 
(7 intermediate revisions by the same user not shown)
Line 6: Line 6:
v3
v3


<div lang="en" dir="ltr" class="mw-content-ltr">
v4
Comparisons, tips, or other information that someone should know before beginning the mod. Mention model compatibility if the mod is only compatible with certain models. Perhaps, if there is a universally better option, suggest it here and link to the wiki page for it.
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
v5
== Required Materials ==
* Tools (T1 screwdriver, Philips screwdriver, soldering iron, etc)
* Modding products (RGB board, cable adapters, etc)
* Components (resistors, capacitors, etc)
* (Optional) Extra things that may make the mod easier or additional pieces you can add onto the mod.
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
v6
== Installation ==
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
v7
=== Motherboard Preparation ===
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
v8
# Disassemble the unit.
# Remove things from the motherboard.
# Add things to the motherboard.
# Bridge these pins.
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
v9
=== Mod Installation ===
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
v10
Choose an installation method below.
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
v11
==== (Option 1) Preserving RF Output ====
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
v12
This method is more difficult but preserves RF output.
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
v13
# Mount mod board at this location (picture).
# Connect wires from here to here.
# Set these jumpers.
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
v14
==== (Option 2) Sacrificing RF Output ====
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
<div lang="en" dir="ltr" class="mw-content-ltr">

Latest revision as of 02:37, 21 September 2024

Other languages:

Este é um teste

v2

v3

v4

v5

v6

v7

v8

v9

v10

v11

v12

v13

v14

This method is much easier but removes RF output.

  1. Mount mod board at this location (picture).
  2. Connect wires from here to here.
  3. Set these other jumpers.
  4. Test the solution by checking XYZ.

Finishing Up

  1. Clean up with isopropyl alcohol and test it.
  2. If testing fails then check X, Y, and Z.
  3. Reassemble the unit.

Usage

  • Give usage instructions if necessary.
  • Cover any additional options post-install, such as configuration jumpers or software settings.

Troubleshooting and Tips

  • List specific tips here or common issues people run into.
Retrieved from "https://consolemods.org/wiki/index.php?title=Example_Page/pt&oldid=48040"