Genesis:Triple Bypass Mod Model 3 VA2

This document will serve as clear step-by-step instructions for installing the 3BP on the Genesis Model 3, revision VA2.

Warnings

Please read the below warnings before proceeding!

This guide expects you to have a basic understanding of how to open up your Genesis Model 3 and to have basic soldering skills.
This mod permanently alters your device.
This mod should not be done by a beginner and is considered intermediate/advanced.
Make sure power is disconnected before proceeding.
After performing this mod you will no longer be able to use composite. You’ll be required to use RGB (or HD Retrovision) cables from this point forward.
Proceed at your own risk!

Start by removing the shell from your console. Remove the 4 screws at the bottom then turn it back upright and lift off the top shell. Remove the screws on the metal shielding and lift the shield off. Next, remove the 2 screws on the sides of the cartridge slot. Now you can lift the motherboard out of the bottom half of the shell.
Cut this trace and verify with a multimeter that there is no continuity between the two points.
Mount the bypass board on the top of the motherboard. The recommended spot is on the right-hand side on the large solder joints sticking up.
Lift the RGB pins (pins 21, 22, and 23) from the CXA1645M chip.
Remove these five components from the motherboard.
Solder three wires from these points to the corresponding ones on the Triple Bypass board.
Remove the components and solder three wires to the Red, Green, and Blue pads and run them through the hole near the edge of the board and connect them to the Triple Bypass board.
The finished product should look like this (minus the orange wire on the Sync pad, which is unnecessary since CSYNC is routed to the DIN connector). See Sega CD Audio section below regarding the wires connected to cartridge connector.