Example Page/pt

From ConsoleMods Wiki
Revision as of 02:37, 21 September 2024 by Rodrigo (talk | contribs) (Created page with "v7")
Jump to navigation Jump to search
Other languages:

Este é um teste

v2

v3

v4

v5

v6

v7

  1. Disassemble the unit.
  2. Remove things from the motherboard.
  3. Add things to the motherboard.
  4. Bridge these pins.

Choose an installation method below.

(Option 1) Preserving RF Output

This method is more difficult but preserves RF output.

  1. Mount mod board at this location (picture).
  2. Connect wires from here to here.
  3. Set these jumpers.

(Option 2) Sacrificing RF Output

This method is much easier but removes RF output.

  1. Mount mod board at this location (picture).
  2. Connect wires from here to here.
  3. Set these other jumpers.
  4. Test the solution by checking XYZ.

Finishing Up

  1. Clean up with isopropyl alcohol and test it.
  2. If testing fails then check X, Y, and Z.
  3. Reassemble the unit.

Usage

  • Give usage instructions if necessary.
  • Cover any additional options post-install, such as configuration jumpers or software settings.

Troubleshooting and Tips

  • List specific tips here or common issues people run into.