PS1:Connector Pinouts
External
AC In (except PSOne/slim)
Main article: Comparison of Power Supplies
Standard IEC 60320 C8 socket taking an equally standard C7 power cable, except in North America where a nonstandard polarized variant is used.
DC In 7.5V (PSOne/slim only)
Exactly what it says on the tin plastic. Negative ground. Same connector as PS2 Slim (7xxxx) but incompatible voltage.
AV Multi Out
Pin 1 is outermost on console.
| Pin | Signal |
|---|---|
| 1 | Green* |
| 2 | Red* |
| 3 | 5 V output |
| 4 | Blue* |
| 5 | ground |
| 6 | Chroma |
| 7 | Composite |
| 8 | Luma |
| 9 | Audio Left |
| 10 | ground |
| 11 | Audio Right |
| 12 | ground |
* Switchable (and defaulting) to Y/Pr/Pb on PS2 and PS3. DVD-Video and BDMV playback artificially restricted to Macrovision-friendly YPbPr mode.
- At higher than standard-resolution modes, only YPbPr or sync-on-green RGB are available.
S-Video (SCPH-1000 only) and RCA (1xxx/3xxx/5000 only)
Industry standard.
RFU DC Out (1xxx/3xxx/5000 only)
TR minijack; tip 5 V, ring GND.
Serial I/O (except PSOne/slim)
| Pin | Signal |
|---|---|
| 1 | RXD |
| 2 | 3.5 V output |
| 3 | DSR |
| 4 | TXD |
| 5 | CTS |
| 6 | DTR |
| 7 | GND |
| 8 | RTS |
Parallel I/O (except 9xxx* and PSOne)
* Double exception for early production, which has the connector but no hole in the case!
Actually a main system bus interface. No official use (for consumers, that is) and primarily used for bootable option ROMs (cheat cards/swap facilitators).
to be written
Controller and memory card
to be written Each memory card socket is actually in parallel with the matching controller port, allowing for interesting aftermarket accessories.
On certain PS2 models (SCPH-75xxx and onwards), however, 7.5 V is not connected on the memory card side, breaking compatibility with older 3rd party memory cards with 5 V logic.
Internal
Power cable
Pin 1 is outermost (facing the power button).
7-pin
| Pin | Color | Signal |
|---|---|---|
| 1 | Brown | Switched 7.7 V |
| 2 | Red | GND |
| 3 | Orange | Switched 3.5 V |
| 4 | Yellow | GND |
| 5 | White | Unswitched 3.5 V |
| 6 | Blue | GND |
| 7 | Purple | Reset-switched 3.5 V |
5-pin
| Pin | Color | Signal |
|---|---|---|
| 1 | Brown | Switched 7.7 V |
| 2 | Red | GND |
| 3 | Orange | Switched 3.5 V |
| 4 | Yellow | GND |
| 5 | White | Reset-switched 3.5 V |
Optical drive
to be written
Disc motor
Pickup & seek motor
Front panel
to be written