CD-i:CD-i 220 RGB Mod
- CDi-220 RGB Mod**
I've only tested a handful of "CDi 220", front-loading units, but as long as your NTSC CDi has the Sony CXA chip, this mod should work for you too. PAL 220's should already have the RGB SCART built-in. That being said, _please_ proceed at your own risk!!!
- Parts Needed:**
You'll need a few tools for this mod (more info on the tools can be found in [tools.html the tools section]): - Soldering skills! - Torx screwdriver set to open the CDi case & internals - Philips head screwdriver - Soldering iron / solder - Thin gauge wire - Four (4) 75 Ohm resistors, the lowest tolerance possible. - Four (4) 220uF/16v capacitors - RGB output port (any port will work, just make sure you pick a port with a matching RGB cable).
- RGB Mod:**
\- Start by removing the top cover: Remove the two torx screws on each side and the top three screws in back: 
\- Next, remove the outer screws that contain the expansion socket. These screws were one size larger torx than the case screws: 
\- Before you can remove the expansion socket, remove the two screws on top, then pull up from the area by the top screws to release the socket: 
\- You'll find the Sony CXA chip underneath the expansion slot: 
\- Solder R, G, B and CSYNC (please see the note about csync below) directly to the chip, as shown here: 
\- Here's the actual chip diagram, in case you're interested (click for full-sized): [[[File:CDiRGB07.jpg)](https://cdn.retrorgb.com/images/CXA1145M.jpg]]
\- Next, choose a mounting location for your RGB port. I chose to use an 8-pin MiniDIN and mounted it where the RF adapter went, allowing the mod to be 100% reversible, without any cutting at all. 
\- Run all four video lines to the output. Make sure each line has a 220uF/16v capacitor on the end, as well as a 75ohm resistor on each line as well. **
**
\- Find a ground point to solder to your connector. There's no "special" place to get ground, anywhere will do (just verify with your multimeter). I used one of the holes the the RF adapter originally mounted to.
\- If your RGB connector routes audio through it, wire that in as well. I soldered my connections to the bottom of the RCA audio ports and ran them through the RF holes to the top of the board: 
- Conclusion:**
The CDi is pretty much the worst console ever made...but at least you can "enjoy" it in RGB! 
Well, that's it! Feel free to go back to the [cdi.html main CDi page]. If you'd like info on mods for other systems, head to the [/systems.html Getting RGB From Each System page] or check out [/ the main page] for more retro-awesomeness.