Search results

===Video Mods=== * <s> Video Output Notes </s>

...PAL GC, 12v will be sent down the sync line! This will most likely damage video equipment it's plugged into.}} ...ponent cable] that performs well.  You can also use the official component cables from Nintendo which are extremely expensive.

...converter pass the Xbox's native Dolby Digital audio signal alongside the video signal via HDMI, which is especially helpful for modern home theater config ...f the cable is set to Advanced SCART Cable, Advanced AV Pack or HD AV Pack video mode.

The GameCube outputs much better quality video than the first versions of Wii systems. ...me basic GC via original Wii comparisons, both with the official component cables: 

...e played in RGB, but the light gun itself needs to plug into the composite video port.

By default, the N64 outputs RF via a RF modulator, and composite and S-Video through the AV output port. There are various mods to add RGB or HDMI outpu ...http://gamesx.com/wiki/doku.php?id=av:nintendomultiav pin 7]) or composite video ([http://gamesx.com/wiki/doku.php?id=av:nintendomultiav pin 9]) on the mult

...GB SCART with video game consoles, Composite Video (cvbs) and Luma (from S-Video) both can be safely used as sync. Some consoles even generate their own ded ...eo signal. If poorly-shielded cables are used, you'll end up with a lot of video interference and most commonly a "checkerboard" pattern.

== Spare Flex Cables == :Spare RCP Flex Cables: [https://www.pixelfx.co/n64digital-spare-flex.html PixelFX.co]

'''RetroTINK-2X Mini:''' An entry-level scaler;  supporting composite and S-Video inputs. ==== 2X Video Product Launches / Reviews ====

...models have it available in stock form. Every model also outputs composite video, which would have been the default choice alongside RF during their heyday. ...out DC offset), and these must be added to the cable itself. The composite video signal can be used for sync, and requires no extra components since it is a

...e HD Retrovision cables and RetroTINK line of scalers can accept composite video as sync without real issue. ...om the S-video connector as a sync source instead of the TTL sync from the video encoder.

...Pioneer/NEC LaserActive is a 16-bit console from the fourth generation of video game consoles. The console was launched in Japan on August 20th, 1993 follo * [[LaserActive:Video Output Notes]]

The Sony PlayStation is a 32-bit console from the fifth generation of video game consoles. The console was launched in Japan on December 3rd, 1994 foll * [[PS1:Video Output Notes]]

...ty. You may see Wii2HDMI dongles out there, they ''negatively affect'' the video signal in their conversion of component to HDMI and it's recommended to avo {{Note|Some newer Wii's output a much higher quality video signal than the originals in unmodified state. Due to a misconfigured low-

CrossPoint is a mostly-retired line of professional analog video switches manufactured by Extron. The switches are favored by retro gamers f Extron CrossPoints are video matrix switches that come in a variety of flavors. Most are designed to be

...Instead, you can use a cable that gets sync from luma (pin 7) or composite video (pin 9) on the multi-out connector (luma recommended). All RGB cables that use CSYNC should have a 330-450 ohm resistor on the CSYNC line. The re

...PC Engine/TurboGrafx-16 is an 8-bit console from the fourth generation of video game consoles. Designed by Hudson Soft and manufactured and sold by electro * <s> [[TG16:Video Output Notes]] </s>

...ertainment System (SNES) is a 16-bit console from the fourth generation of video game consoles. The console was launched as the Super Famicom in Japan on No * [[SNES:Video Output Notes]]

The Nintendo 64 (N64) is a 32-bit console from the fifth generation of video game consoles. The console was launched in Japan on June 23rd, 1996 followe * [[N64:Video Output Notes]]

...ot required since there is no RF oscillator. The tuner, IF amplifiers, and video amplifiers are not Model BG4305 comes with two removable control handles on extension cables. Both handles have a rotary control that moves the vertical position of its